The problem though is that the pairing does not always work as it should. The pairing process does not take a long time and it will be over before you know it. Some people may refer to this button as the reset button and for all intent and purposes, it probably does that function as well. You should find it on the bottom of the camera in a very obvious spot. Where is The Pairing Button on The Furrion Camera? When it has ended, just return the camera to its mounting plate. Press it and your pairing process will start. Next, look at the bottom of the camera for a small button. Once you have power, press the menu button and then click on the pairing option. Now, the monitor has a short plug on its power cable that is to be plugged into the camera. This is done by removing the 4 screws holding the camera to the mounting plate. If yours isn’t, you may have to remove the camera from its place and bring it to the front of your RV or tow vehicle. But not all models will pair up that easily. The reason for that is that the pre-wiring done on your RV is set up to let that pairing take place. Some Furrion models pair up automatically with the monitor.
Different models may have different locations. If you still are not successful, call Furrion and ask them for some advice. You just have to solve the electrical problem to make the camera work again. Follow those instructions to get the right reset and your camera working like normal.īut you may not need to reset the camera if the fuse blew, the trailer lights are not getting power, and so on.
#Furrion vision s manual manual#
If your model is not the same as this particular one, then you should look in the manual to find out the location of the button or the process to reset the camera. Once you push the button you should be able to re-pair your devices as the instructions state. This means that you will have to climb a ladder to get to it depending on the location of the camera. In some models, you may find the reset button on the camera. How you turn it on is up to you and the methods you prefer. Or you can use 2 hot leads to keep the camera on 24/7. If those are not the problem, the camera can be powered by the front electrical compartment using its own dedicated wire. You may not be getting enough power to run the camera.
Or you may own one of those GMC trucks that send a modified 12-volt electrical charge to the trailer lights. This happens a lot and if that is not the problem, check the fuses. If it is not working, check for a broken connection inside the camera. Unfortunately, the instructions do not address all the power failures that can happen on an RV or trailer. It would be easy to just say follow the instructions that came with the camera.
0 kommentar(er)
